Tried searching google but struggled to find any information.
I am familiar with the standard aluminium extrusion process for constant section. I am wondering if there is a possibility to extrude a section lets say circular starting at 100mm diameter reducing to 75mm over an 8m length...
Hello All,
Relatively new to Creo so could be a basic question for some.
I would like to construct a sketch driven point pattern to achieve the following in the drawing:
I can achieve the above with two separate pattern features but not with the desired sketch driven point pattern.
With a...
Hello All,
New to the forum and would just like some other opinion on this subject. I have specified a hole tolerance to accept a bearing, which is a 20.0 H7 +0 / +0.021 the centre position is defined by GD&T position and datum references, the hole depth is around 20mm. The selected...
