Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
GD & T
Thank you both very much. @drawoh, could you please kindly show it on an image, if possible? I have a hard time imagining the datum applied to the pattern. I will appreciate it if you add whatever that might be missing, to make the drawing complete. Thanks again for your time and explanation.- maggie12
- Post #4
- Forum: Student Engineer General Discussion
-
GD & T
Hello, I have a few questions and appreciate your assistance. I was wondering if: 1. The drawing below is complete. 2. Are the positions of the three holes on the left completely defined? Or do I need to define a third datum? 3. Do I need to put all the dimensions into a square (make them...- maggie12
- Thread
- Replies: 3
- Forum: Student Engineer General Discussion
