But what was the Original failure?
Ï I've seen that the badly burnt front unit was henning sent to NTSB in the UD as this might have data after the assumed dual engine shutdown.
There are unfortunately too many people who decide that employment or payment for a contract is worth the low risk that anyone will actually hold you to account for sighing off things that they don't actually believe in. It's only in late years that I've had to do this a few times and held my...
Your finned HX is going to build an ice block on it pretty fast.
I've said we can't check your calculation because you haven't given us enough information, specifically the volume of the vessel and what percent full it is at 300 tons.
Liquid CO2 follows the saturated vapour line so as you do...
If you have a 300 ton tank and remove 20 tons from it and the pressure drops from 15 bara to 6 bara, then the initial volume for the vapour must be minute -
You have filled your tank too high.
It is very unlikely that any product which contains pressure above a very low pressure will be able to be used without a pressure test.
And probably no one would buy it without such certification.
what's a 2oo2 manifold? 2oo2 usually refers to the number of elements in a control loop but...
Wow, 350C!
If you bury something anything over about 85 to 90 c starts causing huge problems.
If this is a pipe wrapped or covered in some sort of insulation sitting with an annulus of a few mm inside a casing and the casing is pretty straight it might work, but you will be getting a whole lot...
Well 50mm of insulation isn't going to work to any decent extent and you will lose a lot of heat and heat up the ground a lot, not to mention the thermal expansion of both the inner pipe and the casing.
What's the temp of the 500 psi steam?
CP of a 200m long line is prob ok with sacrificial...
The pressure drop is relative to the volumes of the liquid and the gas phase. You don't say what that is so no one can work this out.
You really don't want to get to the triple point as it can go solid on you.
You can't just shove in gas and expect tit to liquify it without cooling it.
You...
I can see you're new and young, but this behaviour and language is not tolerated or accepted on this site. Please consider your posts and delete / edit as required.
If engineers cannot converse in a civil manner then no one can. you respond to comments with arguments and alternative opinions...
That's a decent summary I think.
NFPA is the minimum and is generally exceeded to allow for sloshing and waves if indeed it ever happened.
The consequence of bund failure or overtopping if further tanks collapse in the event of a fire from the biggest one ( think rivers of fire!) often cause...
Gear up would start two fairly decent sized hydraulic pumps apprently and hence may have tripped some major electrical system leading to an unintended consequence. Maybe.
That particular plane looks to have had a chequered history and was used for spares for a while reportedly, plus issue on...
That will be a pedestrian bridge two people wide with supports every 40 or 50ft.
This is close to a road bridge with a significant span, plus two sets of lifts either end. They will be $2M each without any effort.
That was ASL. The runway is at about 200ft and when you scale the video they reckon it was about 300 ft. But it wasn't the last minute.
The silence from the investigators is very worrying. Tends to imply the have no smoking gun or the data just stops when the engines stop but they can't work...
So the white bit is the ptfe seal?
Nearest I can find is a BSPT faltface union,.
The groove just looks like an extra to compass the ptfe a bit more given that it's Helium, but if you just want an end for testing a flat face will be more than good enough.
In general insulated pipes do not get any protection from cathodic protection. who is telling you that it actually needs CP?
What type of insulation?
What do you mean by "cased?"
got a cross section you can share?
If this is inserted into a casing pipe which is bored and jacked what are the...
what's wrong with a UT probe?
Never heard of using radiography to determine corrosion before.
but you're prob better looking in the corrosion or QA forum.
Try Sumburgh. They used to put the turbo props into reverse and back up the runway to the very end when they were a full plane then go full throttle holding it on the brakes before catapulting down the runway. Get it wrong and you're in the water...
The opposite was Changi in singapore in an...