I have a series of rollers, same bore configurations just different o.d. geometry. I have created a generic blank (default) part and in that part i have a cut extrude of the roller number. This was created via sketch text. My generic part has "XX". From this part i have created my 16 different profiles and want to change that text for each roller (ie 1T, 1B, 2T....). Can i do this with a design table? Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Modify Sketch Text via design table
- Thread starter Russell67
- Start date
CorBlimeyLimey
Mechanical
Yes and No.
You will have to create the sketch text manually, but once created you will be able to control the suppression state with the DT.
![[cheers]](/data/assets/smilies/cheers.gif "[cheers] [cheers]")
You will have to create the sketch text manually, but once created you will be able to control the suppression state with the DT.
- Status
Similar threads
- Question
- Locked
- Question