Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to create Radial Section Cut on NX Drawing 1
- Thread starter Jashe
- Start date
-
1
- #2
- Thread starter
- #3
Ok Thanks, You could look for a command called "legacy Section" and try to create this view in a model view. But, I do not think this will work without having the PMI License, but you could try.
If this works, you could create this "curve section" and then process this view down into your 2D drawing VIA using the model views.
I hope this helps a bit.
Thanks.
If this works, you could create this "curve section" and then process this view down into your 2D drawing VIA using the model views.
I hope this helps a bit.
Thanks.
- Thread starter
- #5
Thank you for the response. If I had PMI, can you give me a quick synopsis of to go about doing that?
Similar threads
