It seems nobody makes a shaft coupling that steps down 1/4" from 7/8" to 5/8". I am looking for a clamp-style coupling. Hooking up a gearbox that has an output shaft of 7/8" DIA with a 3/16" keyway to a ball-screw setup that has a shaft size of 5/8" DIA with a 3/16" keyway. Any ideas of someone that makes one that can handle these sizes, with or without the keyway? Thanks.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Help finding a shaft coupling 7/8" --> 5/8"? 1
- Thread starter JDubz313
- Start date
-
1
- #2
1 off? ridgid/flex?
Mcmaster has rigid couplers with a fixed 7/8" bore on one side and a machinable-bore (.235" pilot hole) on the other side that you could enlarge to size. (part number 3084K47)
They also have step up/down clamp on shaft adapters.. (like part number 9783T2)
Have you tried Misumi?.. They have a large selection too.
Mcmaster has rigid couplers with a fixed 7/8" bore on one side and a machinable-bore (.235" pilot hole) on the other side that you could enlarge to size. (part number 3084K47)
They also have step up/down clamp on shaft adapters.. (like part number 9783T2)
Have you tried Misumi?.. They have a large selection too.
Just google 7/8-5/8 shaft coupling
diskullman
Industrial
Ruland
Maurey
Russell Giuliano
Maurey
Russell Giuliano
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question