Recent content by zhutao73

Hello everybody, I have a project involving making a flat spring of pre-bended shape. Please look at the picture in the attachment for the final spring shape (without ant loading). I would like to use the spring steel (1074/1095) to do the job. First, I found the spring steel strip in annealed...

Thank you Paul Your information is helpful. I think I really need to get the book you mentioned. It should help a lot. Tao

Hello I am an electrical engineer however have to design a cantilever suspension system even though I do not know much about the spring design. Please look at the attached sketch. I use a flat spring (beam) to suspend an inertial mass to sensoring the ground motion. The beam is intially made...