Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by yurachv
-
Plate marking as per SA-480
Actually, i'm AI, buy that plate not belong to ASME equipment, that plate goes to non ASME-code tank. Long time no see such plates with AISI marking on it, and i wondering is that OK? according to SA-480.- yurachv
- Post #12
- Forum: Boiler and Pressure Vessel engineering
-
Plate marking as per SA-480
Cuz certificate for that plate says: according to SA-240/SA-240M.- yurachv
- Post #10
- Forum: Boiler and Pressure Vessel engineering
-
Plate marking as per SA-480
My concerns were regarding Marking plates as per SA-480, paragraph 25... Actually, i hope for ASME Code expert opinion).- yurachv
- Post #7
- Forum: Boiler and Pressure Vessel engineering
-
results of tests as per SA-480
In Certificate in Remarks its says: "1. we hereby certify that the material described herein has been manufactured and tested with satisfactory results in accordance with the requirements of the above material specification". At the same time, herein certificate any values stated for mechanical...- yurachv
- Post #3
- Forum: ASTM (testing materials) Code Issues
-
Plate marking as per SA-480
I can't find any AISI standard. If you can help with it to understand, I would be grateful to you- yurachv
- Post #5
- Forum: Boiler and Pressure Vessel engineering
-
results of tests as per SA-480
As per SA-480, "8.1 A report of the results of all tests required by the product specification shall be supplied to the purchaser". My concern is: "results" of test shall be in the form of numerical values (for example: Tensile Strength, 460 MPa) OR stated in the notes (remarks) that the...- yurachv
- Thread
- Replies: 5
- Forum: ASTM (testing materials) Code Issues
-
Plate marking as per SA-480
Tnks, I have latest Edition of SA-480 (p. 25 didn't changing). My question is as per SA-480 'the name or mark of the manufacturer' shall be mandatory marked on plates? Also, SA-480 says: "The specification and designation number, and name or mark of the manufacturer shall be marked on the...- yurachv
- Post #3
- Forum: Boiler and Pressure Vessel engineering
-
Plate marking as per SA-480
Is it necessary to indicate the Heat# or Lot# on the plate (plate SA-240, AISI 316L) according to SA-480? Actually i have following marking on plate: "AISI 316L 6x1500x6000". As i understand, as per SA-480 'the name or mark of the manufacturer' shall be marked on plates. Is that mandatory...- yurachv
- Thread
- Replies: 11
- Forum: Boiler and Pressure Vessel engineering
-
welding
When using SA 268, P-No. 7, group 2, to fabricate an unlined water heater, is it permitted to use the welding process - SMAW?- yurachv
- Thread
- Replies: 3
- Forum: Boiler and Pressure Vessel engineering
