Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Wraith

  1. Wraith

    Thread checking

    Does anyone have a very reliable way for checking that holes have been fully threaded and to a proper depth. This application would require a very short cycle time to check the hole. The holes to be checked are M6. Could this be done with the use of an air check probe and sensing for depth with...
  2. Wraith

    Weld testing for projection welding

    Can any-one tell me where I can find facilities to test the strengths and characteristics of projection welds in the Southwestern Ontario area? These places will have to be able to certify the weld test. Destructive or non destructive is fine. Thank you
  3. Wraith

    Weld fume hood calculations

    Thanks in advance. 1-519-680-3884 Wraith
  4. Wraith

    Weld fume hood calculations

    Can any one tell me the best way to calculate the size and equipment required for a welding fume hood? Thanks Wraith
  5. Wraith

    Welding Fume Hood Calculations

    I hope I have the correct area. Can anyone help me with calculating the SCFM for a welding fume hood. I need to calculate the size of piping for the top of the hood and any other information that will be required. Thank you Wraith
  6. Wraith

    Flow drilling??

    I hope I'm in the correct forum, Can anyone tell me where I might find information about the flow dilling process. Information about suppliers for components and general process information would be great as well. Thank you Wraith
  7. Wraith

    Counter bore depths

    Can anyone tell me the standard counter bore depths for SHCS fasteners with Hi-Collar Lockwashers. Metric and Imperial. Thank you, Wraith
  8. Wraith

    Online Info for material specifications

    I am looking for a site that will help me find the specifications for different materials like MS-264-080 XK as far as I can see this is a HSLA 080 material. Can any-one give me some advice as to where I might look for such a site. Thank you Wraith
  9. Wraith

    Non Wear rubber

    I have looked back throught the testing proceedure and all the steps involved are the same in the machine as in the test rig. The only difference is that the pressure for the bladders could have been changed by some one in the machine with out anyone knowing. (Seems to be Very Likely) As to the...
  10. Wraith

    Non Wear rubber

    I have this application were I require a sleave over an inflatable device. The device is a Firestone Air picker. This device inflates from a cylinder shape to a balloon shape. The application I am using this device for is to pick up engine pistons from the sides by inflating the bladders one on...
  11. Wraith

    Affordable 11 x 17 Printers.

    I am curently looking for a new 11 x 17 B/W printer for our design department. We are presently using a Canon BJ 230 B/W that we have had for years and it is starting to slowly give up the ghost. All of the printers on the market are colour and print between 4 to 12 pages per minute. We have a...
  12. Wraith

    Autocad 2000 crashes when plotting to designjet 430

    I purcahsed a designjet 500ps and every time I sent a print to the plotter MDT 5 would give me an error, and then crash. I changed the plotter driver to a 650C plotter driver and I have no problems printing. I found the driver on the MDT5 Program disk. This might solve your problem. I hope this...
See more

Part and Inventory Search

Back
Top