Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by tinashe8

  1. tinashe8

    on load and off load brush gear maintenance

    hie, we have two turbo-alternators installed in the 50's and every time when we want to do brush gear maintenance it is always off load. we have realized the disadvantage of doing this and we are thinking of modifying this excitation system to a system were we can do on load brush gear...
  2. tinashe8

    auxiliary power consumption

    hie, what auxiliary equipment should be left running on a turbo-generator to protect the turbine that may need power from a standby diesel generator? thanks
  3. tinashe8

    motor starting devices

    scotty, other industrial large a.c motors use a star delta starter whereas a motor of the same size is connected direct online in a power station.
  4. tinashe8

    motor starting devices

    why are starting devices used extensively on large a.c machines in most industrial establishments but to a much lesser degree in power stations? thanx
  5. tinashe8

    electric motor bearings insulation

    hello, how are bearings insulated on some machines and why is it neccessary?
  6. tinashe8

    synchronous and subsynchronous content of voltage and current

    what is synchronous and subsynchronous content of voltage and current?thank you
  7. tinashe8

    Oil circuit breaker failing to trip

    what are the causes of a circuit breaker failing to trip? thanx
  8. tinashe8

    generator stator cleaning

    what are the dangers of running a 60MW generator with an unclean stator and rotor. the stator and rotor is contaminated with coal dust. also is it possible to clean the stator with the rotor inside? if possible what method of cleaning can be used to clean the stator with the rotor inside? thanx
  9. tinashe8

    electric motor rewinding

    hello, how do you rewind an electric motor and what equipment is used to do that? thanx
  10. tinashe8

    electric motor cable burn out

    hello, what are the causes which lead to motor supply cable to fail or burn?
  11. tinashe8

    water carryover into turbines

    hello there, how do you prevent water carryover into turbines(steam turbines)? what kind of electrical system can be installed to prevent wet steam into turbines? thanx
  12. tinashe8

    generator brush gear sparking problem

    hello there, what causes generator brushgear to spark and the rotating exciters to burn? what do you recommend to overcome these problems? thank you for your help!
  13. tinashe8

    explanation why generator speed does not change

    why is it that the generator remains at synchronous speed even if you add or decrease amount of steam to the turbine, but the MWs change??
  14. tinashe8

    generator load rejection

    hello there, how does an earth fault on generator feeders cause load rejection? thanx for your help

Part and Inventory Search