Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ThomasTrikowski
-
Amada F0-3015NT Co2 4,000 watt laser cutting conditions
All, I notice every time I run the laser there are problems with 304 Stainless 3/16" and thicker (up to and including 3/8"), A1008 Carbon 3/16" and thicker (up to and including 3/8"), 5052 Alum 1/4" and 6061 Alum 3/8". They all have really bad burrs. I make small changes to the settings, until...- ThomasTrikowski
- Thread
- Replies: 0
- Forum: Student Engineer General Discussion
