Recent content by thixoguy2

Thanks Azrael. The option was staring at me the whole time. thixoguy

Thanks for your input kirrer

Hi All, I flattened some simple sheetmetal parts in "Generative sheet metal" module. All looks good but when I try to create a drawing to export to laser cutter it shows the unflattened parts. Any idea what I might be doing wrong?? thanks thixoguy

Thanks Peterguy, I will try you suggestion

Hi All, Just wondering if anyone understands how to control the transparency level. That is, you are given a slider which you figure would offer you some sort of control. Mine simply acts like an "on" "off" switch. Any comments? As usual, Thanks in advance thixoguy

Ferdo, Thanks very much for the great little presentation thixoguy

Thanks Ferdo, Buuuut............. embarrassingly enough, I have never worked with catscripts, ever. I suppose I will have to look into this. thixoguy

Hi All, I have a fairly large assembly that contains quite a few sub-assemblies. I would like to, if possible, do a "send to" that allows me to select only a few of the sub-assemblies. Is there any way that I can select the subassemlies to send and have the system automatically select all of...

Check this out thread560-230706 thixoguy

Thanks for the quick response solid7. It appeared you were on a bit of a "holiday" for sometime, glad to see you are back. thixoguy

Hi All, I am creating a quick layout for some machines to be placed on our shop floor, it is nothing fancy. I am creating the machine footprints in sketcher. I am identifying the machines by creating an annotation inside the box that represents each machine. Is there a way that I can carry...

Thanks PeterGuy! thixoguy

Hi All, Could someone please refresh my memory... how do you turn on/make visible the scale in the lower right hand corner of the screen? Thanks, thixoguy

DBezaire, Performance is back to noramal, thanks again! thixoguy

Thanks DBezaire, I completely forgot about catsettings. I will try that. thixoguy