u r right Steve. we can have the trail file set to a folder through config file and can be run whenever needed can be edited using notepad and saved). but for big models its not a success always. (maybe 70%)
thilak. regards
thilak
how about deleting the feature and later realising of the need for it "Is there an UNDO for that"???? that's what Mr.dan14 asked I guess.
Am I right ????
regards
thilak
hi gross
Did u try making the feature independent in the copygeom geometry. this gets detached from the assembly that u have taken the surfaces or whatever. the relation can even be taken back when needed by making it dependent.(if the assembly is opened in the session)
Thilak
mageshk
In top down assy, u fix some points first like (as in a bike) the wheel centres, swing arm axis, etc. now u create a skeleton model of curves with these points. with this as the first model in the top down assy, u can create other components in the assembly (atleast partialy). here u...