Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. thilakabr

    torque rod fuctions

    greg I talk about the torque rod at the truck suspension between axle and suspension, on both the sides(LH and RH). regards thilak
  2. thilakabr

    torque rod fuctions

    what is the significant fuction of torque rod in suspension system. what load acts on it? regards thilak
  3. thilakabr

    how to create a mechanism model fro

    how to create a mechanism model from a lyout/skeleton assembly? regards thilak
  4. thilakabr

    what is yaw

    what is yaw and what are its importance in vehicle? regards thilak
  5. thilakabr

    ARE THERE "UNDO" AND "REDO" FUNCTIO

    u r right Steve. we can have the trail file set to a folder through config file and can be run whenever needed can be edited using notepad and saved). but for big models its not a success always. (maybe 70%) thilak. regards thilak
  6. thilakabr

    ARE THERE "UNDO" AND "REDO" FUNCTIO

    how about deleting the feature and later realising of the need for it "Is there an UNDO for that"???? that's what Mr.dan14 asked I guess. Am I right ???? regards thilak
  7. thilakabr

    Pro/E - Copy Geom - Want to break relations

    hi gross Did u try making the feature independent in the copygeom geometry. this gets detached from the assembly that u have taken the surfaces or whatever. the relation can even be taken back when needed by making it dependent.(if the assembly is opened in the session) Thilak
  8. thilakabr

    ARE THERE "UNDO" AND "REDO" FUNCTIO

    no. its there only in the sketcher mode
  9. thilakabr

    Top Down assembly

    mageshk In top down assy, u fix some points first like (as in a bike) the wheel centres, swing arm axis, etc. now u create a skeleton model of curves with these points. with this as the first model in the top down assy, u can create other components in the assembly (atleast partialy). here u...
  10. thilakabr

    p- elements

    what is the major difference between p-elements and h-elements. where are they to be used?

Part and Inventory Search

Back
Top