Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by tahirinst

  1. tahirinst

    I need Prolink III software for Micromotion Flowmeter

    Hi Dave..... thanks for sharing the link. Actually I needed freeware software of Prolink III. Thanks
  2. tahirinst

    I need Prolink III software for Micromotion Flowmeter

    Dear Memebers, I would like to configure Micromotion Flow transmitter. Please share If any body have its software Prolink III ..... I will be very thankful for that.....
  3. tahirinst

    Laying of High Temperature Thermocouple and Ignition Cables

    Dear Electrical / Instrument Engineers, We need to lay high temperature Ignition and thermocouple cables ( non armoured ) from flare ignition panel to flare stack ( approx 100 Meter distance ) Can we lay these cables under ground ( burried ) using 2 inch PVC conduit pipe ( separate conduit pipe...
  4. tahirinst

    Circuit Breaker Sizing for 30 KW Motor

    CB will directly feed the three phase motor.....
  5. tahirinst

    Circuit Breaker Sizing for 30 KW Motor

    I need to install circuit breaker on 3 Phase Motor ( 30 KW). This motor is installed at Screw air compressor ( direct coupled). Motor voltage 400VAC, 50 Hz Please advise size of breaker which should be installed. Motor Name Plate data is...
  6. tahirinst

    What is the purpose of Red and White stripes on Level glass gauge?

    Dear Instrumentation experts, Could you please suggest, What is the purpose of Red and White stripes on Level glass gauge? ( simple hollow transparent tube ). This level tube is installed at open to atmosphere water tank.
See more

Part and Inventory Search

Back
Top Bottom