Recent content by sujins

In some process design, I saw the low/high select signal input to relay to select the source of output signal. The signal may come from HIC or from two controllers (i.e.one from temperature controller and another come from pressure controller)to compare the signal at the relay. How can we...

I've just wonder the function of HIC (Hand indicate controller). Is it used to manual open for control valve,etc during startup or shutdown in process or...? In some design, the system have a control valve which can operate in "AUTO" and "Manual" mode why do we need to have HIC to manual open or...

I can't see any information from your link. Please help answer.

What is the disadvantage of running pump at shut-off head, zero flow rate?

My question is that if I need the pump to run at discharge pressure of 5 barg to compensate for the pressure drop in the discharge line and achieve the required process pressure at around 0.5 barg, then can I adjust the discharge pressure at the pump or it will automatically supply the pressure...

Please any expert explain when operating reciprocating pump. If the process require flow rate with lower pressure than discharge pressure from pump. Let's say required pressure = 5 barg but discharge from pump is 414 barg. How can we reduce pressure? Is it adjustable to achieve the desired value...

Anyone please help explain the function of pressure different switch low low (PDSLL) between the suction and discharge of cryogenic pump. Is it use to protect the pump? or I mean the real reason to have it. Thanks.

Anyone can explain the function of pressure different switch low low (PDSLL) between the suction and discharge of cryogenic pump. Is it use to protect the pump? or I mean the real reason to have it. Thanks.

1) Please anyone can explain more for the topic. How can restrict orifice limit the flow rate? I mean when it is installed to the pipe the flow rate will constant regardless of upstream or downstream pressure, is that right or not? 2)And when sizing the restriction orifice, is it used the same...

Please anyone can explain how can a restriction orifice limit the flow rate of liquid through the pipe. Thanks in advance.

Normally, when we size the control valve, should we use the actual pressure drop or maximum allowable pressure drop that liquid will not cavitate. Anyone can suggest more. Thanks.

When sizing the control valve and after calculate the actual pressure drop of system and maximum allowable pressure drop of control valve, found that actual pressure drop less than max.allowable. Then select the actual pressure drop to size the control valve but the result shown that the...

Please anyone who know where to find the specification of SIVL (super insulated vacuum line)for cryogenic liquid (pipe id., od.,etc) Thanks in advance for suggestion.

Could anyone please explain more!! I haven't yet cleared the point. 1. When we throtting the control valve at the outlet to receive the required flow rate,do the pump regulate itself to the new flow rate and that control valve will absorb for the higher pressure drop? Then the recirculation...

1.Can any expert help explain, what is the minimum required flow rate of pump? 2.In the situation that we have to throttle the discharge flow because the rated flow is not at the intersection of pump curve and system curve(the rated flow is less than the flow at the intersected point, do we...