Trouble making multi entity selection (Sketcher). While holding Ctrl key to select multiple elements in a sketch. Each additional selection is causing previous non constrained elements to move slightly as if I were moving via left click and drag. Even when I'm careful to get on and off the left...
I asked too early ... I found It. It's http://2htts.com/CATBlog/media/common/Catia%20V5%20Parameters%20and%20Formulas%20Tutorial.zip
Props go out to Solid7!
At one time I found a link to another CAT5 site that had a parameters tutorial on it. I've done the tutorial and wanted to revisit it for a refresher. The tutorial was authored by Solid 7 me thinks. Could someone point me in the right dirrection
When I prepare my style data for Developement I'll make curve dirrection always the same ei: start vertex always closest to origin maybe. Then next hood dirrection for copy is correct.
Well done gentlemen. Curve dirrection was a concern for me when Creating Power Copy of adaptive sweep. The Sketch was constrained tanget to intersect curve but result returned to wrong quadrant of tangency.. really weird and Frustrating.. At this time I'm not sure if curve dirrection really...
I'm being interviewed for a position today. One of key points of intrest is the POWER COPY command. I've researched here and some other places but Do not have a grasp on this. I've attempted to excute this function w/o much success. If some one could provide a brief over view/ requirements. It...
There's a sure fire work around. I would not consider this a best practice method but here ya go.
export you geometric set that you want in Drafter as an IGS file (save as). Rename that file with an .IG2 extension this will open in Catia drafting. Copy the newly opened veiw to the desired sheet...
catiajim
Do you ever use the snap command (looks like joined 2 spheres)
To adjust component locations. This will move component locations instantly w/o constraint. Snap together planar faces, planes, vetex, point, axis, cs and combinations of many. Quick and easy. M8
Is anyone aware of a method to select continuous entities. Ie:portions of seperate surface edge boundries or trimmed wire entities. Similar to the autosearch in sketcher. Is there a way to autosearch construction entities?
