Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SS2015

  1. SS2015

    Add Kinematic Model- Mold Wizard- NX 10

    Hello Marcin, Thanks a lot for the reply. I have it installed and can define regions and parting line,.... But not see any kinematic model at the end to preprocess the motion. Sincerely, Shah
  2. SS2015

    Add Kinematic Model- Mold Wizard- NX 10

    Hello All, I have difficulty in using "Mold Wizard" in NX 10. When selecting "Preprocess Motion" in "Tooling Validation", there is no kinematic model shown in the dialog box. I tried also "set press model" in "Die validation" menu, it does not shown any "current Press model" and no "available...
  3. SS2015

    NX 8.0 Moding design, Simulation, Kinematic. How to bring the current model in this window, see atta

    Hi Bogdan, I am using NX 10 and have the same problem. Did you figure out how to get the "kinematic model"? Thanks SS
See more

Part and Inventory Search

Back
Top Bottom