Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by sombreroB
-
GD&T Interpretation - Length of cylindrical feature & end surface form
I believe the drawing is to ASME Y14.5-2009, but I must admit to being unable to distinguish between different versions. Thanks for your comments thus far. I have another question if I may. The depth of the hole on the left hand side is directly dimensioned. Is this correct? My understanding...- sombreroB
- Post #4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
GD&T Interpretation - Length of cylindrical feature & end surface form
Hi, I have a question regarding interpretation of the drawing below. I understand that this is a basic question, but I have so far had little experience with GD&T... My uncertainty concerns the way in which the form of the end surfaces and length are controlled. My best interpretation is that...- sombreroB
- Thread
- Replies: 6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
