Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Skinnedrabbit

  1. Skinnedrabbit

    metalix cnckad

    HI , I USE METALIX )) WHATS UP
  2. Skinnedrabbit

    Amada LC2415 Shutter Enable

    Hi , email is pipeinstallations@btinternet.com Im waiting for fanac to come out to do a mirror clean first and will then have amada come out . Will keep you informed of what they find . Thanks))
  3. Skinnedrabbit

    Amada LC2415 Shutter Enable

    Ok thanks for that , I've bought ours and have had to replace the turbo, 1 power supply and now this . I'll get amada out and if they find the fault will let you know . Do you have the cutting parameters for 4,5,6 mm stainless . By anychance . For some reason they aren't on our controller Thanks rob
  4. Skinnedrabbit

    Amada LC2415 Shutter Enable

    Hi , Just reading your thread ref the 2158 alarm . I have a 1212 1.5kw and we are getting the alarm .Did you find out what it was please . Thanks
  5. Skinnedrabbit

    Cutting parameters for lc1212 2 1.5 kw

    Thanks will have a good read
  6. Skinnedrabbit

    help cutting parameters amada lc2415 fanuc 1500w

    Hi , Do you have any cut conditions for 4mm-5mm-6mm stainless on oxygen . I have the lc1212 1.5kw I've got up to 3mm stainless on clean cut somewhere near if you need them .thanks rob
  7. Skinnedrabbit

    Cutting parameters for lc1212 2 1.5 kw

    Hello , I'm new to laser cutting and have a small job to cut in 6mm gr 304 St/St the machine has no cutting conditions for 4-5-6mm St on oxygen cut . Could somebody help with some parameters please as I'm struggling a little . Have managed today to input a new cut condition for 6mm but seem...
  8. Skinnedrabbit

    amada lc1212 1.5 kw

    Hello , Ive have just bought an amada lc1212/2 1.5 kw with fanuc 16l control . The machine has st/st clean cut cutting conditions up to 3mm but no files from 3-6mm on oxygen . The manual doesnt state how to make a new cutting condition either. I have new /open ect on the soft keys...
See more

Part and Inventory Search

Back
Top