Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SimonFlo

  1. SimonFlo

    Impact testing requirements

    Thanks for the reply, I forgot to mention that these dished ends were cold formed and then normalized which has been done post impact test.
  2. SimonFlo

    Impact testing requirements

    Hello, I have been reading through PD5500 to try and determine if there is a requirement to impact test the following material: BS1501-224-490B-LT50 13mm thick dished end The design temperature is -7degC to +70degC I have been looking at Annex D Figure D.1 and it is unclear as the chart does...
See more

Part and Inventory Search

Back
Top