Does anyone know where I can source Thermosyphon vessels for mechanical seals? I don't wish to buy from one of the large mechanical seal suppliers. I am trying to source the vessel myself and then add my own regulator and fittings.
I am looking for the entry level 10 L vessel for general...
Hi There
DeMin water and carbon do not get on. If you change to a hard faced combination you will remove the issue. I would try Silicon Carbide Vs Tungsten Carbide.
I would also avoid using a PTFE wedge seal. They fret the shaft and just increase your repair bill. If the application is not...
In my experience plan 53A is the most common plan i come across in the chemical industry.
A pressurised vessel used in conjunction with a double mechanical seal. If more heat needs to be removed a cooling coil and finned tubing can be used. A mechanical seal with a pumping scroll can be used...
Thanks..
I think it will have to be Royal Purple although their lowest temperature limit is -65C. I am currently waiting for viscosity data from the supplier.
Thanks
S
Hi There
Are any of you guys using an FDA compliant barrier fluid that can run at between -100C and +150C?
Currently a Dow product called Sylterm XLT is being used. This is very hard to get hold of so we are looking for an alternative.
Do you have any suggestions?
Many THanks
S
Hi There
I work for a mechanical seal manufacturer.
It is normal for the seal pot to rise in temperature under normal operation. This means you are dumping heat from the mechanical seal. You should also notice that one of the two pipes is hotter. This will let you know that the system is...
