Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Saikot Mahmud

  1. Saikot Mahmud

    Generator room ventilation

    At first sorry for the shortage of information The volume of the room is L=132 ft B=66 ft H=20ft There are 6 generator of 1.5 MW capacity of each one, total 8 MW capacity.In summer due to high temperature outside, The generator room temperature is also increasing a lot.As I live in South...
  2. Saikot Mahmud

    Ingresol Rand Air dryer problem

    Sorry information will be Suction pressure 13 bar Discharge pressure 5 bar
  3. Saikot Mahmud

    Ingresol Rand Air dryer problem

    I have air dryer of Ingersoll Rand. It was running smoothly . But there rises problem of shut down and a signal shown on E5A when dryer goes to shut down. What might be the possible causes and what measures should be taken? The discharge air dryer refrigerant compressor was about 13 bar and...
  4. Saikot Mahmud

    Generator room ventilation

    I Have 6 generators of 8 MW capacity in a room of power house.It's a huge problem for us to maintain temperature as the room temperature crosses about 65 degree Celsius.As It's a south asian country, the radiant heat energy is too much for us to handle.The room has four louvers on the rear side...
  5. Saikot Mahmud

    Finding pump operating point

    How can I find the particular pump performance curve?is it available in the net for the KSB pump?
  6. Saikot Mahmud

    Finding pump operating point

    I have different pumps executing different performances.But I am not sure that the pumps are running at the operating point or not? As example I have pump of KSB model manufacturer name: AFFBKB040020. I haven't find any particular project guide on the net for the best operating point.How Can I...

Part and Inventory Search