Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by RoyMultishape

  1. RoyMultishape

    Plot date and file name

    Is it possible to plot the date and file name/location in the corner of a plotted drawing, i am running a acad 2000, The version i am running is a actually called Vector 2d which is based on acad 2000 with their software bolted on, restrictions apply, so is more like an LT version. Thanks for...
  2. RoyMultishape

    Excel custom views

    ByDesign Thanks Really thought this had cracked it, but unfortunatly it still doesn't work for custom views, they remain greyed out throughout the process. Thanks again for your help
  3. RoyMultishape

    Excel custom views

    Thanks for the tip I am not copying,as in copy and pasting to a new sheet, but making a copy of the sheets on the bottom copy/move sht tab, i am not aware of any format controls for this, or are there some defualt format settings for use when copying.
  4. RoyMultishape

    Excel custom views

    Can anyone help? How can i copy a worksheet that contains custom views (Print areas), so that the new worksheet has identical view settings referancing in the new sheet. (when i do this at the moment after copying the worksheet the veiws in the new worksheet default back to the original...
  5. RoyMultishape

    12g Cutting Data

    J Burgess Thanks for the data, is q expressed as a percentage, ie is Q100 = 100%
  6. RoyMultishape

    12g Cutting Data

    Has anyone got cutting data that is faster than 114" or 2900mm a minute? for 12g Cr4, 5" or 7.5" lens. I am using 2kw laser but data for 1500w is equally useful. Thanks in advance for any help.
  7. RoyMultishape

    N2 cutting Mild steel

    chadxyz Yes i do get jittering, I get this when I cut stainless at high speeds, when the laser turns corners dross appears on the rear side, as you said also on block changes. This i think is due to the laser hesitating momentarily as it turns the corner or reads its next command. There are...
  8. RoyMultishape

    Cutting MDF Board On A Laser.

    I always start with Oxygen stainless data. Halve the material thickness i.e 1mm data for 2mm wood, Use air or n2 instead of Oxygen. Careful if the Machine is metal cutting only as filters in the extraction system soon get clogged with wood vapours.
  9. RoyMultishape

    Mazak to Amada code

    Can anyone help me decode the Mazak values P1500 (power)? Q500 (?) R100 (?) F230 (?) as i have found some cutting data in Mazak format but i am having trouble converting it. I use Power, frequency, duty, feedrate/speed on an Amada LC1212. Thanks in advance for any points in the right direction.
  10. RoyMultishape

    prima laser

    This sounds like a gas purging problem, i get the same results when i switch gas, make sure you have no leaks in your lines, I tend to do a test piece first 50mm sq with a hole in the centre, just to make sure the head is purged.
  11. RoyMultishape

    N2 cutting Mild steel

    I am running an Amada Lc1212 and am looking for increased productivity on low gauge mild steels. The latest lasers cut at 20M + per min (1MM mild steel) and they use high power and loads of gas to achieve this.I also know there is a limit to the speed that Oxygen can cut due to exothermic...
See more

Part and Inventory Search

Back
Top