Recent content by psapiensone

this is a good question...you will find the solution! In your 12m you can make many things!

If you have two points restricting the pipe in the same direction, it can not move .... you need to change the design. See the basic rules of piping flexibility. http://currentenergy.blogspot.com/2012/01/piping-stress-analysis.html

I have wind, sesimic and snow. From EN-13480, I understand that: 12.3 Flexibility Analysis eq. 12.3.2-1 (SIGMA 1): SUSTAINED eq. 12.3.3-1 (SIGMA 2): SUSTAINED + SEISMIC/WIND/SNOW eq. 12.3.4-1 (SIGMA 3): EXPANSION + SEISMIC/WIND/SNOW eq. 12.3.4-2 (SIGMA 4): EXPANSION + SEISMIC/WIND/SNOW...

¿how to make the right combination of loads cases using european normative? Thanks!

¿how to make the right combination of loads cases using eurpean normative? Thanks!

I am involved with a new project using european normative EN-13480. My question is about the right cases combination based on thermal stresses. Regards.

you need to learn about piping before to start with Caesar... http://currentenergy.blogspot.com/2012/01/piping-stress-analysis.html

Hi mechanicalman11, I suggest the link below. http://currentenergy.blogspot.com/2012/01/piping-stress-analysis.html All the best!http://currentenergy.blogspot.com/2012/01/piping-stress-analysis.html

I found this good article... http://paulus-sapiens.blogspot.com/2009/03/problem-with-piping-lift-off.html

Hi Guys, I have a problem when I make click in previous screen, my version is 14. Some comments? Regards, Pablo

MECHENG60, you can find some information in the book: Engineering Standard Handbook Of Engineering Calculations, T. Hicks. Reagrds, Pablo

Thanks John, finally I used internal diameter for to do more conservative my calculations. Regards, Pablo

I know exist a very long discussion about these, but can somebody explain to me detailedly this? For example: Can I temporarily delete the supports in the sus case when I have lift off? Thanks. Pablo

Friends, thanks for your answers, the problem is very big now because the client want to use crosses (very crazy) in your project (delayed coker) for cleaning lines. I find information about SIF in an old paper, and in conclusion is possible to use SIF of normal TEE x 1.5 that they tell me...

I need help for find the SIF in a CROSSES and input in Cesar. Regards.