Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by PaulRobertson

  1. PaulRobertson

    Nut Identification

    Usage is only about 750 a year, material steel either stainless or clear zinc plated.
  2. PaulRobertson

    Nut Identification

    This is to bolt a product that we make to a Product/stud we do not make. The studs use to be longer and we had the room to use a standard nut. Now we can only engage 2-3 threads so we need this design to engage a reasonable number of threads. I can change the OD of the piece that the nut goes...
  3. PaulRobertson

    Nut Identification

    Thanks NickE, I should have said cylinder instead of round with the treaded hole being thru. Below is an asci "cross section" ___ ___ | | | | <Hex 13 mm ish | | | | | | | | <cylinder 11 mm ish | | | | -- -- ^ M8 X 1 thru
  4. PaulRobertson

    Nut Identification

    Hi I am looking for a M8 nut that has half a hex body (about 13mm) and half a small diameter (11mm ish) round. Can anyone tell me 1. what is this type of nut called, 2. who sells/makes them. Thanks
See more

Part and Inventory Search

Back
Top Bottom