Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by NITHZ

  1. NITHZ

    Feasible way to obtaining dehumidified air for performing dry-lay up for hydrotested pipe

    Thank You for your kind reply, what i equipment i shall use. I am planning to use a compressor and a re-heater (Heater) to provide dehumidified air. Will it work?
  2. NITHZ

    Feasible way to obtaining dehumidified air for performing dry-lay up for hydrotested pipe

    Thanks For The Previous suggestions, I am struggling to find a feasible way of getting dry air (Dehumidified) for performing Dry Lay-Up for Stainless Steel Piping. Dry Lay-Up is performed in-order to attain the hydro-tested pipes free of remnant water and moisture. Can anyone please help me...
  3. NITHZ

    TYPE OF LAY-UP FOR STAINLESS STEEL PIPINGS

    Thank U Mr.bimr, Thank You for your kind advise
  4. NITHZ

    TYPE OF LAY-UP FOR STAINLESS STEEL PIPINGS

    Thank U Mr.bimr, Actually this for an Aramco Project, the service is for cooling water. This is a pipe replacement project, the previously installed pipes been badly affected with MIC. I have gone through the SAES A-007 already, the problem here is the pipes are loop formed and hence there is...
  5. NITHZ

    TYPE OF LAY-UP FOR STAINLESS STEEL PIPINGS

    Thank U Mr.C2it & 3LittleInch for your valid info, Will take care while making further posts
  6. NITHZ

    TYPE OF LAY-UP FOR STAINLESS STEEL PIPINGS

    CURRENTLY I AM WORKING IN A STAINLESS STEEL PIPING PROJECT FOR THE COOLING WATER SERVICE, I WANT TO KNOW THE METHOD THROUGH WHICH DRY LAY-UP SHALL BE PERFORMED AFTER HYDRO-TEST. EXPECTING VALID SUGGESTIONS
See more

Part and Inventory Search

Back
Top Bottom