Recent content by ngkw1

Hi. I am trying to change my section view setting from the default standard with connector to standard without connector for all my new drawings. I have changed the drawing Document Properties > Section > Standard without connector but everytime I start a new drawing and make a section view, it...

Thanks everyone for the advices. I did what ctopher advised. I was hoping to rotate the solid part along z-axis directly.

Hi. I have created a solid using extrusion. I needed to rotate the solid around z-axis 45 degree. I can seemed to find any command in Solidworks 2004 that allow me to rotate the created solid. I hope someone know how to do it.

Thanks again ctopher

That's great. Thanks ctopher.

enhancement request?? What's that ctopher?

I am sorry I think the chamfer approach proposed by CorBlimeyLimey is also facing similar problem as vertex is not an option to be selected. I tried that and it ends up well, very different.

Thanks for quick reply. CorBlimeyLimey approach is scary if I have a number vertexes to fillet. Is there any other way which is more efficient? As for handleman statement, I am not sure about whether the constant radius or not. However, theoretically, if I look from the top (top surface) and...

Thanks everyone. What's RMB? Is possible to explain how to use link (where is link in the menu?) to do it, CorBlimeyLimey? I think the construction line approach could be messy if I have a row of 8 to 10 holes in the middle of the cube to be positioned at a particular ratio (not necessary in the...

Hi. I am quite new with solidworks. I am using solidworks 2004 and have created a cube with a cole in the middle. I have dimensioned the centre of the hole to the right and left edges of the cube to be the same. Is it possible to put a relationship between the two dimension i.e. the distance...

Thanks CorBlimeyLimey! That's the fillet I wanted to create but one on one vertex and not so many. I can see the picture but I hope you can kindly explain the process of creating it using solidworks 2004. As for whether geometrically possible to have a fillet on a vertex of 3 or more edges meet...

Hi thanks very much for all your help again. But I could not open the file. It says configuration data not available and then future solidworks version. I am using Solidworks 2004. Is it possible create an older version file

Thanks for trying to help. I could find a corner from thr pdf of ctopher that involved a point where 3 surfaces meet. I did notice something like a corner fillet where 3 surfaces meet but it has the edge all filleted as well. The corner fillet will should create a 3D fillet with a fix radius and...

Thank you for replying my query. I hope I am able to fillet it because it seems so simple. I did it with other software with just selecting the vertex and run the filleting which convert it to a 3D fillet years ago. However, now I am using solidworks 2004. I did what Theophilus said but they...

Hi. I am new here and I hope someone can help in this. I am not able to fillet a corner (a point) for a part i.e. a point where 3 surfaces meet. I can chamfer the corner though as the vertex selection is available. I would appreciate very much if anyone can help me in this. Thank you.