Mike,
I'm willing to look into making a small production run as these cross shafts are NLA from Dana and most differential shops.
Tmoose,
I'll post some close ups shortly.
RossABQ,
A Dana 44 is completely overkill and too heavy for my needs. I have a Volvo race car (ironic I know) and the...
Norm,
Impact loads are definitely a factor.
I'm running a solid hub clutch disc.
Philrock,
The shape doesn't lend itself to machining it from a SHCS.
See this link for pictures:
http://wwwrsphysse.anu.edu.au/~amh110/Diff_LSD/diff_lsd_volvo_dana.htm
Thanks for the input.
David
I have an old Dana 30 Powr-Lok limited-slip differential for my club race car. The stock cross pins that the 4 spider gears rotate on and engage the case ramps have a very high failure rate. They fail in the same area each time. It's been a few years since I was in materials lab, but it looks...
