Thanks for getting back to me, yes it took the relay but worst of all it took the card as well which will cost a fair bit to replace.First time id done it so still learning just a shame its going to cost a lot.
Cheers.
Thank you for getting back to me it was a solid state relay a bit like this one
http://gb.mouser.com/ProductDetail/Teledyne-Relays/S20DC30/?qs=sGAEpiMZZMuE7ju2P%2feWHSmA2hcuAuP3080YlDDoVxo%3d
Thank you.
Hi there i work in small plastics factory. we have a 440t molding press, the heats have started to play up zones dropping so we have put it down to one of the relays going so we got a new one but someone(me) put it in the wrong way round.Is this likely cause a lot of problems ie no heats at all...
