Recent content by msouza

Does anyone have or know any supplier for Lube Oil Unit for Hydrodynamic Bearings? Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com

Check this chart please... Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com http://files.engineering.com/getfile.aspx?folder=097c04d3-b39e-4ca0-bcf0-43aed4eb454a&file=Barrier_Fluid_Selection_Guide.pdf

Try it... http://www.flowserve.com/vgnfiles/Files/ProductLiterature/Seals/FTA157_Piping_Plan_Poster.pdf Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com

Is it a Square Seal Flange, due to assembly and access restrictions? Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com

Seal face heat generating is being transfered to the seal pot. You can evaluate if there is any difference between the inlet and outlet port. If the temperature is above of what is recommended by the seal mfg, you can cold de sealing fluid using a coil or something related. Mario Souza...

Flowserve Corporation has a synthetic oils line designed for sealing system. They are called Duraclear and FDA compliance. Hope it can help you! Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com

I think it is a sort of shut off seal, where a rubber is inflated and embraces a shaft, sealing it then. This sort of seal is used in pair with a primary single seal, then, when it is necessary to repair it, the shut off seal is inflated, sealing the fluid and alowwing the maintenance being...

You can use Silicon Carbide x Carbon or even, Silicon Carbide x Silicon carbide with Carbon Impregnated when hard faces are recommended. For this case, the peripherical speed is not high, 14,3 m/s. it should be a challenge if it was upper than 23 m/s. Try Granpc Seals from Brazil, or its...

Have you got an editable file for Positive Displacement Pump API676 Data Sheet, for example in Excel or Word? Where can I find it, at no cost? Thanks in advance. Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com

If you consider using a single mechanical seal, try piping plan 11/62, with Direct-Sintered Silicon Carbide x Carbon (not antimony carbon), 316 metal parts and Fluoroelastomers gaskets. As a piping plan 62, it will have continuously quench, not accumulating crystals. Perhaps a rotating bellows...

This is the propective compound... Parker V1289-75 can be used until -55°C. This is also known as Cryogenic Buna or Nitrile. Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com

Some seal manufacturers use to recommend using water only with less than 65°C for sealing lubricating. It is far correct that above of it, water has poor lubricity, but how can it explain the use of Carbon x Silicon Carbide for LPG services, with its common low viscosity... It makes me consider...

Carbon x Silicon Carbide is a good options, since the Silicon Carbide can run better than Tungsten Carbide under extreme temperature conditions (and its possible variantions), SC is less sensitive than TC concerning temperature variations. For gaskets an special Parker Buna compound can be founf...

Perhaps you can see a suitable option in this chart attached here... Let me know if it is useful. Regards. Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com...

We have already got the paper copy, but buying only the excel version for data sheets is too expensive. Thanks LSThill, for sharing the link!!! Mario Souza Application & Product Engineering WMF Solutions Brazil http://www.wmfsolutions.com