Feeling like a total newb today - but I have to ask:
Where did the 3D Text Tool get buried in NX6? I looked in the usual spots, but could not find the tool. HELP!
Figure I would bump this up to the top - seeing that my inquiries at Siemens have been hazy. Has anyone in the community run into trouble when creating attribute fields with special characters - or used values with special characters?
For those that deal with the "meta data" side of the CAD world - i.e. storing material specs, vendor numbers, etc. - what have you seen as do's and don'ts for Attribute Nomenclature in NX6 - especially when you use those Attributes with the rest of the Siemens family of products, like TeamCenter...
Ladies and Gents,
Working on a project where functionality was "enhanced" by a series of regeditted drop down additions. Honestly, it has been a long time since I did regedits - so does anyone have a good regedit guidebook, especially for Siemens products?
NXConsultants - actually, I did take the BBS route on the Siemens sight first, as well as nag what contacts I have with Siemens, before I appealled to the audience here.
When you say it is working correctly for other people in the department - they are translating over the same (component, subassembly, assembly?) or their own files?
