Recent content by mrr1671

Hi, I have a problem and hope you can help me, I am looking to what material should be a straight knurled pin that needs to be press fit into a hole of a shaft made of SS 303. Current material of pin asks for the same material 303 but the knurl of the pin does not cut or makes interference on...

If somebody knows, an horizontal motor can be mounted vertically? It's a small motor Frame 56 1/2HP. My concern is on the bearings. Thanks.

Hi, somebody knows where can I find information about the clasification of terminal boxes for motors, the box that come mounted directly over the motor. Thank you.

No it's not, it looks like but probably because I am Mechanical Engineer and don't know too much about the electric motors.

Hello, I am not an Electrical Engineer but I need to measure the vibration on a motor that is controlled by a VFD for variable speed. I have read that a VFD converts the AC current to DC and then converts again into AC but something that is called modulated (PWM), which gives a different...

Hi, is there a way that a database created with the Autodesk Val-Editor for custom parts can show up when I open the Standard Parts Database? Thanks.

I just want to thank you for all your help, your advices help me to solve my problem, I have finished the drawings. I am using the Autocad Mechanical 2004 and the company standards say that only geometry is to be in the Model, everything else should be in Paperspace. Thank you very much...

Hi, I have the next problem and maybe somebody can tell me how to solve: I have all the geometry for a part in Model and all the dimensioning in PS, the problem is that I need to re-arrange the views in order to add more details, I am doing this zooming in/out the model into the PS, doing this...

Thanks to OCCO for the links, this is what I was looking for. [bigsmile]

Diamondjim, thank you for your help. Yes the tip is almost pointed, as you described. Do you know which will be the formulae or how to calculate the tooth thickness and the diameter over wires?.

Thanks for your information, Do you know where can I get more information on these types of gears?

Hi, I have some problems trying to determine and finding information regarding the right dimensions for this spur gear: N=9 P=20 Pressure Angle=20 The diameter over wires using 0.096" wires is specified 0.6159"-0.6144" depth of cut is 0.1120. I was trying to review if this data is okay but...

Does somebody knows how to model or where to find the way to model a gear in Catia. Thanks! [bandito]

Hello EngJW, I found the next address that may have what you are looking for: http://www.ul.ie/~nolk/gears.htm#To%20construct%20a%20gear%20profile%20using%20Unwins.

Use AcadExcel, I try it and found that is easier that any other method. Look on http://www.lyrasoft.net/