Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by More1Putts
-
Perpendicularity to a Wedge
thank you both for your input. We will incorporate that in our drawing.- More1Putts
- Post #6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Perpendicularity to a Wedge
The wedge feature aligns a laser used for calibrating a system. The holes tie the plate in the drawing to a fixture. It is critical that the wedge feature is perpendicular to the two hole pattern to reduce error in the system alignment.- More1Putts
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Perpendicularity to a Wedge
Good morning, I have a unique problem in the GD&T world. I have a wedge shaped feature that is symmetric to the vertical centerline. I am trying to ensure the circled hole pattern is perpendicular to the wedge feature. Any assistance would be greatly...- More1Putts
- Thread
- Replies: 5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
