Recent content by miller7778

Right click the assembly in the feature tree, go to properties, and check "flexible"

I personally always go with the new install. Upgrades are usually bad news in SW world.

Rockguy, textures now show up in regular drawings as well as edrawings.

Sooooo many things. 1. The addition of the width mate. This alone has saved me so much time it's unbelievable. 2. The ability to rotate views within a drawing. 3. Sheet metal bend notes. 4. Linked split pane views I can't think of any more right now, but I would have a hard time going back...

It finally converted over and opened, but it's a pretty good size assembly. I've never opened a 3d DXF before so I was surprised that it broke it into 54 parts. It's around 28m total size in a zip file now. If you want it, I'll try to send it to you, but I don't have any webspace to upload...

It crashed my solidworks the first time. I'll try again during lunch.

I'm in the process of opening one with SW06 to see how it works. If it goes ok, I can convert it to iges or something and send it to you.

haha I give up....

errr http://img149.imageshack.us/my.php?image=rotatingsliderlink24vy.png

Image below http://img149.imageshack.us/my.php?image=rotatingsliderlink24vy.png

I have a link with a curved slot in it that a rod slips through. The link should be able to slide and rotate at the same time along the length of the slot but I can't seem to mate it in a way that allows this to happen. I tried searching this forum, but really didn't know what to look for...

How do you do this?

No and after all of my files were saved to 06 files, it stopped happening. :shrug:

I can't recreate it yet. Hole wizard seems to work fine. Did you disable antivirus when you installed?