Recent content by MattBryanton

Thank you for the reply Chris but your link is for thin films. I need to source a much thicker, solid tube and sheet/block materials. Matt Bryanton

Hi all, I am looking for a supplier of high purity PFA tube and sheet material, preferably in the UK. Dupont 450 HP or similar would be ideal. Dimensions are as follows; Tube: 60mm OD, 4mm wall thickness, 250mm lengths Sheet: >28mm thickness, >80mm x 80mm Many Thanks in advance, Matt Bryanton

I'm aware of the following. http://www.amc-mmc.co.uk/ http://www.tisics.co.uk/ Not sure whether either can help with your particular applications. Thanks, Matt

carbongr, the forum you describe sounds like the old netcomposites forum. Unfortunately the forum is no longer supported but you should find plenty of useful information on the website at www.netcomposites.com. There is also an industry directory on this website which should help. The...

In the UK the EngD is mainly run for those who work towards the qualification whilst remaining in full time employment. More info at http://www.lboro.ac.uk/cice/whatis.htm Hope this is of interest. Matt B

You should probably start with the following book... Frequency Selective Surfaces: Theory and Design by Ben A. Munk "A You can get it from many places including Amazon. Hope this helps. Matt

Kevin, take a look here http://www.baesystems.com/atctowcester/ Matt Bryanton

Does anyone have any information regarding the recent changes in legislation relating to the amounts of Boric Oxide permitted for use in the manufacture of E-glass? I have been told by my supplier that the Boric Oxide content will drop from 5% to 3% and while this has no significant effect on...

Hi all, I need ANY information you have available on the fatigue properties of composite sandwich panels with aramid paper honeycomb cores. Specifically, I'm interested in the in-plane properties of panels with glass or quartz composite skins. Thanks, Matt B

Hi there. Agusta and Westland are a couple. Go to http://www.agustawestland.com/ for info on these. Sikorsky probably do as well - www.sikorsky.com I'm sure there are many more... Matt B

I'm interested in the maximum size that I can obtain boards in. My total requirement is for 30 square metres and the larger each of the individual boards is the better. At this stage a continuous roll greater than 1m wide would be great if anyone could do it. If not then what is available to me...

Hi, I forgot a couple of points. The minimum separation in the pattern is 200micron. At this stage I need about 30 square metres. in the long term there may be a requirement for bulk manufacture - it depends on how I get on with the prototype. Thanks, Matt Bryanton

The short answer is that I don't mind where the samples are manufactured. Obviously there are reasons why I would prefer them to be manufactured in the UK or Europe but I think that my requirements are fairly demanding and I would be interested to learn of ANYONE that could assist me with this...

According to the website the maximum size they can manufacture is 12" (300mm) by 14" (350mm). Thanks anyway.

Hi, I have a requirement to manufacture large, flexible (polyimide), double sided PCB's. Can anyone give me information on companies that have the capability to manufacture boards larger than the 600mm wide? Ideally I'd like at least 1metre x 1metre. Thanks. Matt B