Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MartijnKlok
-
Reusing punched (countersunk) holes in sheetmetal
Well, i might just need a good "How to"to get them set properly. What is actually the faces/features that you would use as UDF? I have tried it with a punch defined from a sketch. but when i tried to reuse, i needed to set a Csys, and couln'd position the udf where i wanted. At least i know...- MartijnKlok
- Post #3
- Forum: Siemens: UG/NX
-
Reusing punched (countersunk) holes in sheetmetal
Hello, I'm net to this forum and new to NX, so i may have a dumb question, but can't find good answers on the internet of other threads. We are currently using inventor, and that has I-features, we modeled a punched, countersunk hole in a part of sheetmetal, set that as an ifeature, and can...- MartijnKlok
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
