Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by lisetteterry

  1. lisetteterry

    Design Moment Versus Maximum Moment

    thank you handex! that is the exact answer we just figured out over here.
  2. lisetteterry

    Design Moment Versus Maximum Moment

    Hi, Can anyone tell me the difference between the Design Moments (Top/Bottom) and the Maximum/Minimum Moments. When looking at the analysis results tables I realized that the maximum/minimum moments (from the strip forces table) is about 35%-50% less than the design moments (from the flexural...
  3. lisetteterry

    lateral load to slab due to earth pressure

    Did you try drawing a null slab area (on the part of the slab with the lateral load) and adding a pressure instead of a line load? It sounds like what you did was to put the load on the wall and if the load does not transfer to the slab then it would not affect the slab.
  4. lisetteterry

    SAFE Design Strips are getting deleted

    Hi, I have encountered some sort of a bug in SAFE where it is deleting my design strips when I run the model. I have my design strips spaced at 1 meter in both directions on the slab. I am using SAFE Version 12.3.0. It is only 3 design strips that keep getting deleted. It is the same 3...
See more

Part and Inventory Search

Back
Top