Hold for the "wrong" plane vs pass behind the "wrong" plane makes no difference in the outcome because the helicopter would have still proceeded forward enough to be in the path of the plane that hit it.
Good job though continuing your role of being the proper word use police, and also posting...
You mean actually doing like she was told to do, when told to pass behind the plane? Because she was directed to pass behind the plane, meaning she needed to wait for it to cross in front of her.
You really like posting in circles, circles, circles.
Hold where exactly? Short of the path of the wrong plane she was watching? How does the pilot be precise about their "hold" position when hurtling through a dark night sky?
Exciting current for the motor comes from the DC bus. Never from the AC source. The input on the AC source is only the real power to rotate the motor.
The post edison123 made isn't even that dramatic a difference. I've seen it much larger when spinning an unloaded motor on a VFD.
The big...
Around here, it's common for the rural customers to put in their own poles and overhead line for the utility to feed directly off the power line at the road. I believe the transformer can either be leased or purchased, but it's possible the utility provides it on the customer pole instead of at...
The prime mover (engine) produces kW. Changing the kVAR only does not change the kW load on the prime mover hence doesn't change the amount of fuel used. You can't change just the kVAR in practice, but assuming you could it doesn't affect the fuel used.
The kW is used by customers and by...
The prime mover load produces the kW. Changing the VARs produced doesn't affect the engine load.
Correcting the power factor could cause a reduction in kW due to less cable or transformer losses with the lower current, but it is a secondary effect. A bigger kW change might be possible by...
Hmm, so there was a minimum distance. Imagine that...
Even without a fixed number, far enough away you don't crash would be the minimum distance to stay back, not trying to pass 25' under the landing gear.
The minimum separation distance sets where they were not supposed to go.
They were not able to simply stay below 200' and do as they please. If they were, then they could have just dropped lower and buzzed the landing gear of the plane without a care in the world.
Float it to the same circuit as the gate drive for the SCR cathode connected to that heatsink then convert to an optical signal to send back to the controller.
They were given instructions, not just information.
If you actually read my posts instead of trying to find ways to defend your crap, you'd see that I (me, myself) posted that they had to hold and that I NEVER posted anything saying ATC told them to hold. So, get over it. ATC told them to cross...
