Recent content by KooKoo

I suggest logging a PMR. This error message is as common as Command interrupted.

Have you tried decreasing the spacing?

I tried that but once in the GPS workbench CATIA sees the split surfaces as individual surfaces (not joined). In the first example I tried I took a rectangular surface and split a circle in the center (without using the Datum icon). When meshing I had to mesh each surface individually. Next I...

If I understand you correctly you can't apply boundary conditions because when you try to add loads, or restraints or .... the whole surface\volume gets pick. Or am I totally of? Try splitting the surface into areas where you want to apply your BCs. When you do the Split, select the Datum icon...

Try the Reflect Line. This will create the parting line. You can construct your parting surface from this curve.

Try this thread http://www.eng-tips.com/viewthread.cfm?qid=92712

Do you mean when you record the macro then go back to edit the script all you have is Sub and End Sub? I get that often even outside of FreeStyle.

What I meant was sketching the lines first using the Line or Profile icon, constrain them using Geometrical Constraints or Driving Dimensions then "tracing" over them when creating the section line. Use the right mouse button for additional options when sketching the section line.

Creating the circular reference (in Pro/E anyways) is no problem. Sometimes they can get created without intending to. I ran into this a lot using Pro/MOLD. I found the models I worked with that had circular references were unstable. PTC always told us to fix them.

What about creating your part drawing section lines as sketched lines in the drawing instead of the part?

Do know much about VB but my best guess is the CATScript file it creates can be modified to run and change the desired settings (instead of going to Tools, Options to do it). This can be useful if you change settings often. No need to go to Tools, Options just run the script.

May also be able to use a Multi-section solid\surface.

Here's a related post: http://www.eng-tips.com/viewthread.cfm?qid=89597

You said it "Standards". Check this site for related posts (setting up drafting standard, admin mode.......) Also have a look at the documentation.

The link below takes you to IBM PLM Support. https://www-304.ibm.com/jct03004c/software/applications/plm/support/support.wss You can search for stuff under Self help or submit defects under Problem submission. Sorry couldn’t be more help, we’re not on R15.