It sounds to me like it was a magnetic pulse that took out your weatherhead.
The old "opposites attract" and "likes oppose" can really put a hurting on anything nearby. :)
Ever see a welding cables slap together? Or hear wires "ringing" in a conduit during a dead short? The magnetic pulse...
Either way you are going to have losses, but with electricity you can't easily add sections of cable (ever make up an armored cable? It's a bear).
As much as I hate hydraulics, I would say that in this case it's the easier of the two options.
I bought one for a project at work, it was extremely cheap (as PLCs go) and it was a cinch to program. I downloaded the *free* programming software and had my program written in just a few hours. It was simple. :)
The software is great, I'd say it's better than anything from Rockwell. Or GE, or...
Could be. Put a scope on it and see what kind of noise you are getting back from your IR sensors.
Here's what the manual has to say about it:
Probable cause:
"Either noise, lightning, improper grounding, lack of surge suppression on outputs with inductive loads, or poor power source."
So...
Here ya go. :)
I exported it to a L5K file (open it in RS5k and save it as FIFO Example or whatever).
I didn't pick any particular processor, or I/O, etc. But you shouldn't have any trouble editing it...
In the spirit of OOP (particularly the "code reuseability" part), I'm going to recycle some puesdo-code I wrote earlier tonight for your problem.
For our example let's create five tags (DINTS would be fine). call them Reg1, Reg2, Reg3, Reg4, and Reg5.
Do this for each of your four pumps:
If...
I don't have any experience with a S5, so how about some puesdo-code?
Pick an area of registers that are available to you, for our example we'll pick ten of them. And for our example we'll say that they are registers 1 - 10.
This arbitrary limit of ten registers assumes that you would never be...
Well, like I said in my previous post, I haven't tried it as of yet (I'm still in Kentucky). And like I also said in my previous post, I wouldn't ever seriously implement it.
But for curiosity's sake, I'm going to run a test just to see what it does. Why not? I'm entitled to a few "stupid...
It's DC, I don't see why not...
Well, if you get it from a company like Milwaukee Resistor, then they will be able to point you in the right direction. But basically you will have to fuse it and enclose it inside a case or behind a plexiglass cover to keep it out of way of wandering fingers...
Back in the 80's LoveJoy (the coupling people) branched off into the drive business.
For testing and burning in their drives, they used two AC motors, one 1800 RPM and the other 1200 RPM coupled together to provide a load for the AC drive (the drive was connected to the 1800 RPM motor).
This...
