Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jmmr

  1. jmmr

    Reading a Kollmorgen drive parameter using Siemens Step 7

    Yes to all. I currently write the opmode (parameter 930) to the drive.
  2. jmmr

    Reading a Kollmorgen drive parameter using Siemens Step 7

    I am trying to read a parameter from a Kollmorgen S300 servo drive over Profibus using an S7-300 controller and Step 7 program. I have setup the program per the Kollmorgen manual ( task ID = 1, Parameter Number = 1724, Parameter Index = 1. I send out the command to the drive but the response...
See more

Part and Inventory Search

Back
Top Bottom