Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jefrojo

  1. jefrojo

    Calculation of position tolerance with reference to hole

    pmarc, Yes, for the tolerance on the corresponding threaded hole, I based it on the Fixed Fastener equation, so it will be .1 .
  2. jefrojo

    Calculation of position tolerance with reference to hole

    Thanks J-P.
  3. jefrojo

    Calculation of position tolerance with reference to hole

    Thanks for your answers J-P, I attached another quick sketch with the actual dimensions I would like to put on the drawing. So from your post, the datum shift is not "usable" to give me a bonus on the tolerance zone of each hole. Season Lee, I'll take a look at your link. Thanks...
  4. jefrojo

    Calculation of position tolerance with reference to hole

    Hi all, When calculating the positional tolerance of a pattern of holes that are on a bolt circle and are located by a shaft going into a hole, do I get any bonus/minus because of the value of the adjustment between the hole and the shaft at MMC? (See attached) With the fixed Fastener equation...
See more

Part and Inventory Search

Back
Top Bottom