Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by jadham2
-
Geometric tolerances to control rectangular form of 2.3mm thick pad of IN70 material
Hello guys, I have question regarding addition of Geometric tolerances to control rectangular form of 2.3mm thick pad of IN70 material. do we required it on drawing ? if yes how they will measure this for this thick material ? if no, how they will make sure that its rectangular & not...- jadham2
- Thread
- Replies: 5
- Forum: Mechanical engineering general discussion
