Recent content by hoots1

Thanks, i will do so.

I am designing a crank shaft with a reaction load R1 - 130,000 lbs. Second bearing is @ 14.5 inches away from R1. R12 - is 138,000lbs.R1 and R12 has a common crank pin.Rod load on the pin is @ 250,000 lbs. I need to see if any one can tell me how would I detemine the basic load rating and...

thanks.

Do you mind to tell,what kind of pump did you do. Can you share the design ?? if not patented.

I am designing a swash pump , i need assistance in designing the slider bearing forces, friction and heat generation due to friction and torque to spin the wobble plateto overcome the friction. whoever has designed a swash pump would be helpfull.

thanks for the help.

I think, I may have confused you, in explaining what I am looking for. I want to know how much is the flow coming out of the 1/4" and the 1/2" hose. if the manufacturer recommends a 35 gpm gear pump that is feeding the 1" oil lube manifold.

I need help to calculate oil flow rate on lube system on a triplex pump. I have a 1" input lube manifold that is 3.5 ft long. On One side is the input and the other side is plugged. Three, 1/4 " dia, 1 ft long hoses are connected (90 degree to manifold)to the lube manifold at 10 inches away...