Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Happyfeet63
-
GD&T re Hex shaft with 2 different Hex sizes
In the revised drawing, I want the small hex of the gauge to be parallel and within angular tolerance in relation to the large hex. Do the GD&T specifications appear reasonable and measurable...- Happyfeet63
- Post #4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
GD&T re Hex shaft with 2 different Hex sizes
Thanks for the FYI re: "drills" (FYI, when I was physically able I was an avid woodworking hobbyist and the use of "Drill Bit" I suppose has crept into my vocabulary). . The notation on the drawing of "Drill Center" is not a negative symbol but rather a "Tilde" (~) which in "Elizabethan" time (a...- Happyfeet63
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
GD&T re Hex shaft with 2 different Hex sizes
I am an ME, now disabled, working from home (95% for my 35 yr. career was spent in mfg. mgmt. – so I am very rusty) and am designing a drilling center for drilling a hole in ea. side of a Hex coupling nut (simultaneously). Need a bit setup gauge for bit changes in the drill heads utilizing the...- Happyfeet63
- Thread
- Replies: 4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
