I found these links that will give you the gasket dimensions and flange dimensions:
http://www.aalco.co.uk/literature/literature.html#stainless
Look at literature "Hygienic Tubes and Fittings"
CAD download of BS4825, pt 3 files can be found at...
I found a site with good dimensional information at:
http://www.aalco.co.uk/literature/literature.html#stainless
Look at literature "Hygienic Tubes and Fittings"
CAD download of BS4825, pt 3 files can be found at:
http://www.dpluk.co.uk/cad_files/cad/hygiene_tubes/CLP.DXF
Any other good links...
Thanks for the help. I have an application where I am constrained to use 3" sch 40 pipe. I must also maintain the nominal 3.068 ID thoughout my system. I do not see any prefabricated quick release flanges for sch 40 pipe that I can procure. Therefore I'm looking for dimensions on existing...
Does anyone know where I can find detailed dimensional information on Tri-Clover Tri-Clamps? I have a special application where I would like to use a 4" tri-clamp. I have not been able to find anymore that overall clamp dimensions.
Thanks for the help.
Thanks for the reply. You're right the section I quoted is not applicable. I believe that the system would be designed to B31.3 for systems under external pressure since I will be operating at a negative pressure.
I appreciate all the information members to this forum can give me in relation...
I'm looking at the design of a pneumatic transfer system. This system will transfer small samples in plastic carriers. The carriers are transferred via an induced vacuum on the downstream side of 3" PVC or CPVC plastic pipe lines to its desired location. The customer for this system requires...
I notice that there are many manufacturers of Reinforced Thermoset Plastic (RTP) vessels that say they design, fabricate, test, and document their vessels per ASME RTP-1 code requirements but do not have the ASME certification for the RTP-1 stamp.
I’m trying to determine the reasons or...
