Recent content by GrzegorzD

Thanks a lot for your response. My problem disappeared after using start model with all settings. Thank you all once more Gregor

Hello all, I have a problem with changing the 1ST ANGLE PROJ (current) to 3RD ANGLE PROJ because I have to make the drawings. I can't find the suitable option which could allow me to change. Maybe someone knows how it would be possible? Thanks in advance Gregor

GrahamBennett, thanks for the answer. You are absolutely right with the low temp performance - I've just checked it in the table. But I am curious if it is the only (together with the cost) parameter which allow using CR instead of nitryle rubber.

I wonder why in car industries material for CV Boots was changed from nitryle to chloroprene rubber. Would you like to give me the answer? Thanks in advance Gregor

Hello Everyone, I have a problem with solution based of suspension bushing (rubber to metal; or rubber to plastic one) with requirement of high resistance against radial force (about 4,35kN) and very low torsional stiffness - or even slipping (I have to achieve torsional movement as low as...

Thanks a lot Azrael, I know that it was silly question but I just started... By

Hello, I'm just started working with CATIA 5.14 (early it was CATIA 4.2.4). And I have a problem with copying the parts. How can I copy the part and avoid the association with the first one. I mean that when I change the parameters for the "oryginal" it shouldn't change the copied part. Thanks...

Thanks a lot, I try to find that book Best regards Greg

Thanks GregLocock, You are right - I have found the same in the internet. Do you know some books or web sites where I can find some more information about stabilizer bars (and mountings). I am resposible for the rubber to metal mountings for them now and frankly speaking the kinematics and...

Hello All! I have to compute the angles for the conical and torsional work of metal-rubber ends for the stabilizer link. I have a sketch witm the position of REB position MEJ and MTM position and Design Position. I have a problem with Design Position only because I don't know about initial...

Hello All, I am working on rubber bushing of stabilizer bar. It's for car suspension. The radial stiffeness should be 4kN/mm (+/- 15%), torsional 1 to 1.5 Nm/deg and conical < 1.5 Nm/deg. Greg - you have told above that the there no conical deflection: "GregLocock (Automotive) 15 Dec 05...

Thanks a lot averyone!

Hello, I'm looking for information about clear chromate and yellow dischromate coating. Full text about corrosion protection attached: CORROSION PROTECTION: ZINC PLATED 0.0003 MIN THICKNESS PLUS A CLEAR CHROMATE OR YELLOW DISCHROMATE DIP WHICH MUST WITHSTAND 96 HOURS UNDER ASTM B-117 SALT SPRAY...

Thanks a lot adyonel!

Hello, I'm looking for a European equivalent (e.g. DIN, EN, ISO) of American material: steel 1018-1022, plain, case hardened thickness .006/.015, case RC45MIN, core RC - 28/36 This material is used for bolts/screws Any help is gratefully received. Greg