Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by GarbageGuru
-
Modelling Coating in Abaqus
Have you done anything similar like this before regarding modelling coating as a cohesive element? I mean all I need to do is run a shear test and get the correct parameters for my model, but I am honestly not sure if that would be an accurate way to model coatings. I could not find any journal...- GarbageGuru
- Post #3
- Forum: DASSAULT: ABAQUS FEA Solver
-
Modelling Coating in Abaqus
Hello everyone. I am trying to model a coating sandwiched between two plates in Abaqus and running a 2d simulation, so I cannot use SKIN. I was thinking of inputting the coating as a cohesive element. Is that accurate?- GarbageGuru
- Thread
- Replies: 3
- Forum: DASSAULT: ABAQUS FEA Solver
