Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Ganolli

  1. Ganolli

    Door Plate / Flush Type Cleanout

    Pow you are the man thanks !
  2. Ganolli

    Door Plate / Flush Type Cleanout

    Hi, I am wondering, is it possible to do a 10ft by 10ft or 8ft by 8ft flush type cleanout? Basically, instead of having a welded door plate, we would like to have one that we can bolt. Anyone knows where to start with this? Thanks,
  3. Ganolli

    MT on temporary attachments

    Hi ! I have a question concerning MT on temporary attachments. If we look at art.7.2.3.5, it says that we only have to MT areas where temporary attachments have been removed on plate materials from group 4, 4A, 5 and 6. So, if I have a plate from group 3, I wouldn't need to perform MT in this...
  4. Ganolli

    Top Angle Minimum Weld to Shell

    The tank is 72ft high, it has a C.A., and it must be calculated to sustain wind load in the corroded condition....Things get pretty nasty...
  5. Ganolli

    Top Angle Minimum Weld to Shell

    Hi ! I have several individuals telling me differents things here, and I can't find a clear statement anywhere in the API. What is the minimum fillet weld I can use when welding a top angle to a shell plate ? For example here, if I'm using detail b from figure F-2 of the API650, and I have an...
  6. Ganolli

    Stainless Steel Tank Flat Spot / Deformation

    Since some of you guys are very knowledgeable and experienced in the Storage Tank domain, I was wondering if your could provide me some guidelines/solutions to an issue we are presently having out on the field. We are currently erecting a Stainless Steel Storage tank (mat SS316L). During...
See more

Part and Inventory Search

Back
Top